|Top Width:||32mm||Angle (°):||40°|
32mm Width flat rubber drive belts,
Height 19mm flat rubber drive belts,
19mm Thickness small rubber drive belts
Special Rubber V Belt For Tractor, Long Service Life Rubber V Belt
The shuangli V-belt is manufactured by German technology. The inner core is made of tempered wire with a solid core and untwisted structure. It has zero elongation, flex resistance, high strength, good adhesion, and the service life is increased by 5-10 times, which effectively solves the
In the case of low friction, the V-belt is prone to damage. It is very important to avoid grease on the timing belt during use. It is necessary to pay attention to it during use. Oil has the effect of reducing friction. It may cause poor use of the triangle belt. Excessive friction may also be damaged, especially if it is stuck in one position for a long time, the quality of the V-belt often has problems. It is necessary to pay attention to avoiding the wear of the V-belt at the same position, and check to find out in time. Problem solves the problem.
|Type||Top width(mm)||Belt Thickness (mm)||Angle (°)||Production scope (lnch)|
|Can be customized according to customer requirements|
Triangle belt is also called V belt, also known as the cloth V belt
The triangle has two kinds of special core structure and rope core structure. The core, usually the band core, is twisted or woven with fiber. Special belt core is composed of polyester toughened brown silk, good adhesion, flexure resistance, high strength, no extension, its service life is 5-10 times of the rope core structure triangle belt.
3. Classification (by model)
Triangle belt by model can be divided into: usually V belt and narrow V belt
Usually v-shaped triangular belts are divided into seven grades: Y, Z, A, B, C, D and E
Narrow V bands are divided into usually narrow V bands and strong narrow V bands.
Usually narrow V with SPZ, SPA, SPB, SPC four models.
Strong narrow V with XPA, XPB, XPC
A combination of V bands, several of the same common V bands or narrow V bands working together. There's 3V, 5V, 8V and so on.
4. Model (usually model of triangular belt)
The section area of Type O, Type A, Type B, Type C, Type D and Type E tapes is gradually expanding.
When the top width and thickness are determined, the wheel groove of the belt pulley of the triangle belt can be confirmed. On the contrary, the wheel groove of the belt pulley can be confirmed and the type of the belt that should be used (A/B/C..) can be confirmed. .
Ld: Reference length. When the triangular belt rotates and bends around the pulley, the layer whose length and width remain unchanged is called the neutral layer. Under the specified tensioning force, the circumference measured along the neutral layer of the triangular belt is called Ld, the reference length
La: Outer circumference
Li: The inner circumference
Lw: Nodal length is the midline length of the triangle belt
Contact Person: admin