|Top Width:||38mm||Angle (°):||40°|
23mm Thickness Rubber V Belt,
38mm Width Rubber V Belt,
E type 38mm Width rubber drive belts
Sincerely Brand All Types Of Narrow V Belt Customized Belts , Hight Abrasion Resistant
Introduction to triangle belt knowledge and inspection methods
ordinary belt core:
Most of the cores of the ordinary V-belt with core are cord cores, and a few of them are cord fabric cores. Since these two core structures are fiber twisted or woven, the inter-fiber shearing causes the core to gradually break and elongate during operation. Therefore, the production of cord and cord cores can only be used in low-load transmission systems.
|Type||Top width(mm)||Belt Thickness (mm)||Angle (°)||Production scope (lnch)|
|Can be customized according to customer requirements|
Triangle belt is also called V belt, also known as the cloth V belt
The triangle has two kinds of special core structure and rope core structure. The core, usually the band core, is twisted or woven with fiber. Special belt core is composed of polyester toughened brown silk, good adhesion, flexure resistance, high strength, no extension, its service life is 5-10 times of the rope core structure triangle belt.
3. Classification (by model)
Triangle belt by model can be divided into: usually V belt and narrow V belt
Usually v-shaped triangular belts are divided into seven grades: Y, Z, A, B, C, D and E
Narrow V bands are divided into usually narrow V bands and strong narrow V bands.
Usually narrow V with SPZ, SPA, SPB, SPC four models.
Strong narrow V with XPA, XPB, XPC
A combination of V bands, several of the same common V bands or narrow V bands working together. There's 3V, 5V, 8V and so on.
4. Model (usually model of triangular belt)
The section area of Type O, Type A, Type B, Type C, Type D and Type E tapes is gradually expanding.
When the top width and thickness are determined, the wheel groove of the belt pulley of the triangle belt can be confirmed. On the contrary, the wheel groove of the belt pulley can be confirmed and the type of the belt that should be used (A/B/C..) can be confirmed. .
Ld: Reference length. When the triangular belt rotates and bends around the pulley, the layer whose length and width remain unchanged is called the neutral layer. Under the specified tensioning force, the circumference measured along the neutral layer of the triangular belt is called Ld, the reference length
La: Outer circumference
Li: The inner circumference
Lw: Nodal length is the midline length of the triangle belt
Contact Person: admin